Compile Error With Latest Merge #1140
Replies: 2 comments 13 replies
-
|
The one template I didn't check... I'll fix it |
Beta Was this translation helpful? Give feedback.
-
|
Done. |
Beta Was this translation helpful? Give feedback.
-
|
This is new, I've never had a choice of environments before |
Beta Was this translation helpful? Give feedback.
-
|
I'm getting the same results as described here: |
Beta Was this translation helpful? Give feedback.
-
|
Oh, so the probe assist tramming is not working. |
Beta Was this translation helpful? Give feedback.
-
Probe assist tramming would just be the "Use Probe" option in Manual Leveling, right? If so, then yes. I've never been able to get it working properly. I just paper level it and run a 15x15 mesh after I mess with the setup in a way that could knock the plate out of level. I really do want to get the assisted tramming working though, it looks like I could really dial in the plate with some hard numbers to work with. |
Beta Was this translation helpful? Give feedback.
-
If anyone else runs into this, it's referenced upstream here. The takeaway is that some stuff gets renamed and PIO gets confused, so deleting the .pio folder is sufficient instead of making an entirely new clone, or at least that was the case for me. |
Beta Was this translation helpful? Give feedback.
-
|
@AshenColors Make sure you are using JyresUI, the default commit at the top of the branch list. Use one of the templates in the E3V2 config files. |
Beta Was this translation helpful? Give feedback.
-
@Jyers Using 3X3 Manual Mesh template. Error when compiled.
Beta Was this translation helpful? Give feedback.
All reactions