Autobed level gets to Probing Point 157/225

[apr1967]

Installed E3V2-UBL-BLTouch-15x15-HS-v4.2.2.

Did a manual level using the firmware (nice!)
Set Z
Turned on UBL and had it probe. It gets to point 157/225 and stops (no error) saying you must remember to save it as its only in ram.

Is 157 points all it is supposed to probe? 15x15 = 225 but I didn't learn new math, so I'm a bit confused.

Nope 157 is correct. Not all points are probe able. Found that by searching on 157.

Am I following the right steps? After this is done, I would assume I am ready to do a test print, or should I check X again?

Because my simple test print is still failing.

As long as my mesh is saved in ram I should just be able to run any gcode, a home will automatically reload the mesh correct, or do I need to add the m240 -L?

[Jyers]

See #419 and #403. I'm working on a status message will hopefully make this more clear in the future. As far as the gcode take a look here: https://github.com/Jyers/Marlin/wiki/Configuration-Details The UBL section details exactly what is needed for UBL to function properly.

[apr1967]

Thanks.