Retaining Mesh After FW Flash #877
Replies: 3 comments 2 replies
-
|
The UBL mesh should be retained after flashing, it certainly does for me using 1.3.2. It is stored in a separate area of memory. Make sure the mesh is saved after creation, and check that the mesh can be re-loaded and viewed correctly from the menu. |
Beta Was this translation helpful? Give feedback.
-
Unfortunately "Manual Mesh" is saved on eeprom. Jacobs explained that a short while back. The UBL mesh is saved on a dedicated slot. So it doesn't get wiped after a reset/reinstall of firmware. |
Beta Was this translation helpful? Give feedback.
-
|
What is the difference between UBL with no probe vs. manual mesh? |
Beta Was this translation helpful? Give feedback.
-
|
Sorry, should be more specific. I ment ubl with bl touch. Read this about
the no-probe. It’s in the Wiki.
https://github.com/Jyers/Marlin/wiki/Configuration-Details#ubl
Op za 22 mei 2021 om 15:55 schreef embraceentropy ***@***.***>
… What is the difference between UBL with no probe vs. manual mesh?
—
You are receiving this because you commented.
Reply to this email directly, view it on GitHub
<#877 (reply in thread)>,
or unsubscribe
<https://github.com/notifications/unsubscribe-auth/AGXIODJHMEFRKKR5ASPDVBTTO6ZUNANCNFSM45J7HDAQ>
.
|
Beta Was this translation helpful? Give feedback.
-
|
Thanks, didn't think to check there. I just compiled a UBL-No Probe version and am going to try it tonight |
Beta Was this translation helpful? Give feedback.
-
I have come to enjoy staying current with FW changes and trying new things. However, I've come to hate having to go through manual mesh generation every time I flash a new FW and reset/re-save settings. I've noticed things like LCD Beeper setting, UI settings, etc appear to be retained after resetting EEPROM after FW flash.
Would it be possible to have an option to retain mesh after EEPROM reset?
Beta Was this translation helpful? Give feedback.
All reactions