Extruder direction of rotation

[Bersaker]

Hello, Is there a way to set the direction of rotation for the extruder in the menu? Or can you only do that directly via the firmware or the cable on the connector? It would be a good idea to be able to change this in the menu.

Tkaus

[smooreace]

Did you try setting e-steps to a negative number?

…

On Fri, May 28, 2021 at 8:00 AM Bersaker ***@***.***> wrote: Hello, Is there a way to set the direction of rotation for the extruder in the menu? Or can you only do that directly via the firmware or the cable on the connector? It would be a good idea to be able to change this in the menu. Tkaus — You are receiving this because you are subscribed to this thread. Reply to this email directly, view it on GitHub <#925>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/AIPE4Q6DE2JM75B4FZLEJODTP6HV7ANCNFSM45WSNRSQ> .

[Bersaker]

Can only be negative. up to 0 is not possible