Meshsense Behaving differently between ESP32 and nRF52 devicesd

[Soupbones]

I am running Meshsense which is a great free program for monitoring your local Mesh LoRa network, but I have noticed some strange things. So I run my Meshsense on a RAK 4631 and 19007 board combo running 2.5.13 firmware in client mode.. This works great with Meshsense though it does seem to notm traceroute sometimes. The other issue is the app will not draw lines between nodes its seeing with fresh traceroutes either. So if i take this off and connect Meshsense to my Heltec V3 ESP32 board, which is running firmware 2.5.9 and running in Client Mute mode, the Meshsense screen will show fresh lines as it connects to nodes. or will show lines from a traceroute.
I can't work out why this is happening. I am considering rolling back the software on the RAK to the same as the V3 and see if that makes a difference. But I csnt otherwise see why it does this. Not sure if its a firmware thing with Meshsense, or a Board type (ESP32 vs nRF52) thing with meshsense. Anyone else able to test this issue?