• cn
• en

操作指南

此SDK仅适用于以下产品型号:

• LDROBOT LiDAR LD19

0. 获取雷达的Linux SDK

$ cd ~

$ mkdir  ldlidar_ws

$ cd ldlidar_ws

$ git clone  https://github.com/DFRobotdl/ldlidar_stl_sdk.git

1. 系统设置

• 第一步，通过板载串口或者USB转串口模块(例如,cp2102模块)的方式使雷达连接到你的系统主板.
• 第二步，设置雷达在系统中挂载的串口设备-x权限(以/dev/ttyUSB0为例)
  • 实际使用时，根据雷达在你的系统中的实际挂载情况来设置，可以使用ls -l /dev命令查看.

$ cd ~/ldlidar_ws/ldlidar_stl_sdk

$ sudo chmod 777 /dev/ttyUSB0

2. 编译

$ cd ~/ldlidar_ws/ldlidar_stl_sdk

$ ./auto_build.sh

3. 运行

$ ./build/ldlidar_stl <serial_number>
# 例如 ./build/ldlidar_stl /dev/ttyS0

Instructions

This SDK is only applicable to the following product models:

• LDROBOT LiDAR LD19

0. get LiDAR Linux SDK

$ cd ~

$ mkdir  ldlidar_ws

$ cd ldlidar_ws

$ git clone  https://github.com/DFRobotdl/ldlidar_stl_sdk.git

step 1: system setup

• Connect the LiDAR to your system motherboard via an onboard serial port or usB-to-serial module (for example, CP2102 module).

• Set the -x permission for the serial port device mounted by the radar in the system (for example, /dev/ttyUSB0)

  • In actual use, the LiDAR can be set according to the actual mounted status of your system, you can use 'ls -l /dev' command to view.

$ cd ~/ldlidar_ws/ldlidar_stl_sdk

$ sudo chmod 777 /dev/ttyUSB0

step 2: build

$ cd ~/ldlidar_ws/ldlidar_stl_sdk

$ ./auto_build.sh

step 3: run

$ ./build/ldlidar_stl <serial_number>
# eg ./build/ldlidar_stl /dev/ttyS0